Skip this chapter if you have already installed the toolhead by following the instructions of the chapter Assembling the Machine Body of Ray.
¶ Before You Start
Make sure the machine is powered off.
Do NOT plug or unplug any cables when the machine is powered on.
¶ Procedures
- Attach the toolhead bracket to the X axis.
- Loosen the handle of the toolhead bracket, and slide the toolhead into the bracket.
- Adjust the height of the toolhead vertically until the bottom of the slider is level with the bottom of the bracket. Then, tighten the handle of the bracket.
- Insert the toolhead cable into the toolhead.
For subsequent instructions on how to fix the toolhead cable, the X-axis cable, and the air tube, refer to Step 27-29 and Step 30-33 in chapter Assembling the Machine Body of Ray for complete information.