¶ Parts List
The Laser Module and the Air Assist Pump are not included if you purchase the Ray Machine Body separately.
The spare laser lens protector is used for maintenance. For more detailed information, refer to Replacing the laser lens protector of the laser module.
¶ Procedures
- Attach the foot holder to the cylindrical foot.
- Attach the cylindrical foot to the foot connector.
- Identify one Linear Module labeled with "Y" on the cable connector. It will be the left Y axis.
Take care to avoid injury from sharp edges of the steel strip.
Do not press the steel strip.
- Attach two foot components to the left Y axis.
- Identify one Linear Module labeled with "Y" on the cable connector. It will be the right Y axis.
Take care to avoid injury from sharp edges of the steel strip.
Do not press the steel strip.
- Attach two foot components to the right Y axis.
- Insert the dowels of the left linear module connector into the dowel holes of the left Y-axis slider.
- Attach the left linear module connector to the left Y axis.
- Insert the dowels of the right linear module connector into the dowel holes of the right Y-axis slider.
- Attach the right linear module connector to the right Y axis.
- Move the linear module connectors to their lowest reachable points.
Take care to avoid injury from sharp edges of the steel strip.
Do not press the steel strip.
- The Linear Module labeled with "X" on the cable connector will be the X axis. Insert the dowels of the left linear module connector into the dowel holes of the X axis.
Take care to avoid injury from sharp edges of the steel strip.
Do not press the steel strip.
- Attach the X axis to the left linear module connector. The screws installed in this step should not be fully tightened until Step 17.
- Insert the dowels of the right linear module connector into the dowel holes of the X axis.
- Attach the X axis to the right linear module connector. The screws installed in this step should not be fully tightened until Step 17.
- Move the X axis to its lowest possible position, adjust the Y-axis position to ensure that the Y axes are level with each other.
- Tighten the screws on the linear module connectors.
- Attach the cable clips to the X axis.
- Attach the cable clips to the left Y axis.
- Fix the left Y-axis cable to the cable clips on the left Y axis.
- Attach the cable clips to the right Y axis.
- Fix the right Y-axis cable to the cable clips on the right Y axis.
- Attach the toolhead bracket to the X axis.
- Loosen the handle of the toolhead bracket, and slide the toolhead into the bracket.
- Adjust the height of the toolhead vertically until the bottom of the slider is level with the bottom of the bracket. Then, tighten the handle of the bracket.
- Insert the toolhead cable into the toolhead.
- Fix the toolhead cable with the cable clips on the X axis.
- Fix the toolhead cable with the cable clips on the right Y axis.
- Fix the X-axis cable with the cable clips on the right Y axis.
- Attach the M5 air tube connector to the toolhead.
- Insert the air tube into the M5 air tube connector.
- Fix the toolhead cable and the air tube with cable ties, as illustrated.
You can cut a longer cable tie into multiple shorter cable ties for use.
- Fix the toolhead cable, the X-axis cable, and the air tube with cable ties, as illustrated.
- Screw the Wi-Fi antenna into the integrated controller, then rotate the antenna so that it is facing upwards.
- Insert the microSD card into the integrated controller.
- Attach the foot to the cylindrical foot.
- Attach the cylindrical foot to the laser engraving and cutting platform.
For instructions on how to place the platform, refer to section 3.2 Placing the laser engraving and cutting platform, in the online Quick Start Guide.