¶ Selecting positioning method based on the laser module model
- From the middle, move the X-axis to the back end, and move the toolhead to the rightmost position.
- Place the laser engraving and cutting platform and adjust its position until the white vertical line on the label and the outermost horizontal edge of the platform coincide with the crosshair of the red light.
You can move the toolhead to the leftmost position to check if the platform is aligned.
- After the platform is properly positioned, move the X-axis and the toolhead closer to the center to release the trigger of the Y-axis limit switch.
If the indicator light of the work switch is flashing red, you need to press and hold the work switch for 3 seconds to unlock the machine.
- From the middle, move the X-axis to the front end, and move the toolhead to the leftmost position.
- Place the laser engraving and cutting platform and adjust its position until the white horizontal line on the label and the outermost vertical edge of the platform coincide with the crosshair of the red light.
You can move the toolhead to the rightmost position to check if the platform is aligned.
- After the platform is properly positioned, move the X-axis and the toolhead closer to the center to release the trigger of the X-axis limit switch.
If the indicator light of the work switch is flashing red, you need to press and hold the work switch for 3 seconds to unlock the machine.