You can start printing on Luban or on Touchscreen.
You can start printing on Luban via Wi-Fi or via USB cable.
If the Wi-Fi network becomes unstable or disconnected during printing, the ongoing job will not be affected. you can still control the printing and adjust the parameters on the Touchscreen.
If the USB cable is unplugged during printing, the ongoing job will be stopped immediately and cannot be resumed by replugging. Also, you cannot control the printing process or adjust parameters on the Touchscreen, of which the function is sustituted by Luban in this case.
You can transfer files to the machine via Wi-Fi or USB flash drive, then start printing job on the Touchscreen.
If you need to adjust settings, please tap Adjust Settings prior to printing or swipe left on the printing process screen.
If the Wi-Fi network becomes unstable or disconnected during printing, the ongoing job will not be affected. you can still control the printing and adjust the parameters on the Touchscreen.
If you need to adjust settings, please tap Adjust Settings prior to printing or swipe left on the printing process screen.
Once printing starts, keep a close eye on the first layer of the model so that problems can be detected in time to avoid wasting filaments. If the first layer does not adhere to the glass platform, stop printing and refer to - First Layer Does Not Stick.