¶ Parts List
¶ Procedures
- Install the PEI glass plate.
PEI glass platforms are fragile and should be handled with care.
- Place the printer indoors on a solid horizontal table or workbench.
In order to facilitate filament replacement, it is recommended to leave a space of more than 30 cm around the machine.
- Thread the connecting cable through the hole, and then lock the print cooling fan into place.
4. Open the front doors, and then install the screws.
To install screws with the provided hex key:
1.Screw the screw into the hole with the long handle;
2.Tighten the screw with the short handle.
- Connect the print cooling fan. Stick the cable clip to the back panel, and then press the cable into the clip.
- Install filament holders.
- Place the top panel.
- Connect the power cable.
Before connecting the power cord, make sure that the power switch is off, otherwise the printer may be damaged.