Cloud mode, not available in Local Area Network mode.Fixed an issue where the device did not respond when moving the Z‑axis in 0.1 mm steps.
Fixed an abnormal page jump in the Wi‑Fi Management page after tapping the Enter key on the soft keyboard.
Fixed an issue where, after resuming a print job started via the official client, unused channels would still check filament information.
Fixed an issue where the enclosure setup guide would not display properly after completing the U1 initial setup wizard.
Improved the tip‑forming effect during filament unloading, reducing the chance of failure caused by filament expansion.
Enhanced loading and unloading efficiency, shortening waiting times.
Settings > Maintenance > Toolhead Info, and re‑run Multi-toolhead Offset Calibration and Heated Bed Leveling.