Firmware V1.1.0 and above requires Snapmaker Orca V2.2.1 (or above) or Snapmaker App V2.2.1 (or above).
- Added selective flow calibration. Users can choose specific toolhead(s) to perform flow calibration, avoiding redundant calibration on already calibrated toolheads to reduce preparation time.
- Added QR code guidance to certain error message pages. Users can scan the QR code to access the official solution for the corresponding issue, enabling faster troubleshooting.
- Added support for additional official RFID filament types.
- Optimized cooling fan control logic to reduce fan noise from idle toolhead(s) during printing.
- Improved the AI defect detection model to reduce false positives.
- Optimized print time calculation logic. The duration shown on the print completion page now reflects the actual printing time, excluding paused time.
- Adjusted Z-axis motor current parameters to increase Z-axis output torque, improving print quality issues caused by insufficient torque.
- Added a medium sensitivity option to the filament tangle detection feature.
- Optimized the UI display for storage space management.
- Auto-Refill is enabled by default after updating the firmware.
- Fixed an issue where the firmware could shut down if the start G-code did not include a layer count command.
- Fixed an issue where the nozzle temperature could be modified unexpectedly during pre-extrusion.