¶ Before You Start
Make sure the machine is powered off.
Do NOT plug or unplug any cables when the machine is powered on.
¶ Tools & Accessories Required
- Air assist pump × 1
- M5 air tube connector × 1
- M8 air tube connector × 1
- Air tube × 1
- Cable tie × 3
¶ Procedures
-
Attach the M5 air tube connector to the toolhead.
-
Insert the air tube into the M5 tube connector.
-
Use the cable ties to collect and fix the toolhead cable and the air tube.
-
IF you have installed the Enclosure, thread the air tube through the snap bushing to the outside of the Enclosure.
-
Use the cable collector to organize the air tube together with other cables.
-
Attach the M8 air tube connector to the air assist pump.
-
Insert the other end of the air tube into the M8 air tube connector.
-
Insert the cable of the air assist pump into the illustrated port of the integrated controller.
To pull out the tube from the tube connector, firmly press the round clamp while pulling.
