¶ Problem Description
The machine return error message "The temperature control of the left/right extruder is abnormal.".
¶ Posible Causes
The extruder has a bad contact to the PCB.
¶ Solutions
¶ For the right extruder
-
Power off the printer.
-
Loosen the two screws on the side of the extruder with the provided pink hex key (size H2.0) in the toolbox without unscrewing.
-
Roll the knob on the right print head in the right-hand direction, until the Hot end kit is released completely.
-
Pull the Hot end kit down to take it out.
-
Push the Hot end kit back into the print head.
-
Roll the knob in the left-hand direction, until it could not be rolled anymore.
-
Power on the printer, start the Bed leveling and check if this error would happen again.
You'll need to run the calibration again to align the left and right head.
¶ For the left extruder
-
Power off the printer.
-
Loosen the two screws on the side of the extruder with the provided pink hex key (size H2.0) in the toolbox without unscrewing.
-
Pull the Hot end kit down to take it out.
-
Push the Hot end kit back into the print head.
-
Roll the knob in the left-hand direction, until it could not be rolled anymore.
-
Power on the printer, start the Bed leveling and check if this error would happen again.
You'll need to run the calibration again to align the left and right head.