The recommended temperature for Snapmaker J1/J1s is 10°C to 35°C (50°F to 95°F).
Fused Filament Fabrication (FFF) technology is very sensitive to temperature. To ensure ideal printing results, place the 3D printer at the recommended temperature.
If the temperature is too high, it may affect the printing effect of some filaments (such as PLA), and may damage the 3D printer components. If necessary, use a fan or air conditioner to reduce the temperature.
If the temperature is too low, it may also affect the printing results of some filaments (such as ABS and PA). Another adverse effect is that prints are prone to edge warping: with the cold air, the top layer of extruded filaments will shrink; The bottom layer, which is continuously heated by the heated bed, expands and warps. If necessary, use the air conditioner to increase the temperature.
The temperature of the operating environment suitable for each filament may vary. It is recommended to refer to the information provided by the filament manufacturer for detailed guidance.
The recommended relative humidity for Snapmaker J1/J1s is 10%-90% (no condensation).
The humidity of the operating environment suitable for each filament may vary. It is recommended to refer to the information provided by the filament manufacturer for detailed guidance.
Make sure that the table on which the printer is placed meets the following requirements: