When Snapmaker J1 and the computer running the Snapmaker software are connected to the same network, you can slice in the Snapmaker software and start printing directly.
After generating the G-code file in the Snapmaker software, click Export > Load G-code to Workspace.
In the Preview window, click Start Job > Start on Luban to start printing.
After printing, pay close attention to the printing of the first layer of the model, so as to find problems in time and avoid wasting filaments. If the first layer does not adhere to the glass plate, stop printing and refer to First Layer Does Not Adhere.
If the Wi-Fi network is unstable or disconnected during the printing, the ongoing printing process will not be affected.