¶ Introduction
This guide provides a detailed, step-by-step process for replacing the top cover kit on the Dual Extruder of the Snapmaker 2.0 and Artisan models.
¶ Tools Needed
- New top cover kit
- Top cover
- Connector wedges
- Quick-connect fittings
- H1.5 screwdriver
- H2.0 screwdriver
¶ Safety Precautions
When removing or reinstalling the Dual Extruder, please make sure the machine is powered off. To avoid any issues, be careful not to plug or unplug anything while the machine is on or accidentally connect things the wrong way.
¶ Step-by-Step Instructions
¶ Step 1 Install the connector wedge and quick-release fitting onto the new top cover.
The connector wedge is pressed in from the top down, while the quick-release fitting is inserted into the gap between the connector wedge and the top cover.
 |
 |
|---|
¶ Step 2 Remove the four screws from the old top cover
Using an H1.5 screwdriver, carefully remove the four screws securing the old top cover.
¶ Step 3 Remove the front door panel and hot ends
¶ Step 4 Remove the four screws from the back of the Dual Extruder
Utilize an H2.0 screwdriver to take out the four screws located at the back of the dual extruder.
¶ Step 5 Extract the internal module from the outer casing
Gently push the internal module out of the outer casing to gain access for further steps.
¶ Step 6 Remove the four screws securing the top cover to the main control board
With the H2.0 screwdriver, detach the four screws holding the top cover to the main control board.
Note that one of the screws is positioned in the center:
¶ Step 7 Secure the new top cover kit to the main control board
Remove the old top cover and attach the newly assembled top cover kit from the step 1 to the main control board, ensuring it is securely in place.
¶ Step 8 Reinstall the modules and screws
Following the disassembly steps, carefully reinstall each module and screw to complete the process.
¶ Contact Support
If you encounter difficulties during the installation process and wish to seek assistance, kindly submit a support ticket through https://snapmaker.formcrafts.com/support-ticket to contact Snapmaker Support.
Our dedicated support team will be more than willing to assist you in resolving the issue.