¶ Problem Description
Artisan's Linear Module hits the limit switch and generates noise when moving.
¶ Possible Cause
The limit switch is faulty or damaged.
¶ Solution
¶ Before You Start
- Contact Snapmaker in advance and get a replacement limit switch.
- Have the screwdriver provided with the machine ready.
- Make sure to shut down the machine.
¶ Procedures
-
Unscrew the two screws and an iron piece fixing the steel strip at the limit switch end.
-
Unscrew the two screws fixing the limit switch.
-
Unplug the limit switch cable and replace the limit switch board.
-
Tighten back the two screws fixing the limit switch.
-
Tighten back the two screws and the iron piece fixing the steel strip at the limit switch end.
-
The limit switch replacement is completed.
-
After the replacement is completed, please control the movement of this linear module through the screen and observe whether abnormal noise still occurs when the slider moves to the limit switch.
-
If the abnormal noise disappears, the problem is solved.
-
If the abnormal noise persists, please contact Snapmaker again.