¶ Introduction
This guide provides a detailed, step-by-step process for replacing the XY linear module cable on Artisan.
¶ Tools Needed
- New XY linear module cable
- H2.5 screwdriver
- H3.0 screwdriver
¶ Safety Precautions
-
When removing or reinstalling the linear module, please make sure the machine is powered off. To avoid any issues, be careful not to plug or unplug anything while the machine is on or accidentally connect things the wrong way.
-
During the operation, you may need to handle the steel strip, which has sharp edges. Please exercise caution to avoid any cuts or injuries from the steel strip.
¶ Step-by-Step Instructions
¶ Step 1 Remove the two screws that secure the steel strip.
Locate the side of the linear module that is connected to the linear module cable, and then use a H2.5 screwdriver to remove the two screws that secure the steel strip.
¶ Step 2 Remove the four screws securing the end cap
Use an H3.0 screwdriver to remove the four screws securing the end cap.
¶ Step 3 Carefully lift the end cap
Carefully lift the end cap and locate the connection point of the linear module.
¶ Step 4 Unplug the old linear module cable from the PCB board
¶ Step 5 Plug in the new linear module cable
Locate the new linear module cable and plug it into the PCB board
¶ Step 6 Reinstall the modules and screws
Following the disassembly steps, carefully reinstall each module and screw to complete the process.
¶ Contact Support
If you encounter difficulties during the installation process and wish to seek assistance, kindly submit a support ticket through https://snapmaker.formcrafts.com/support-ticket to contact Snapmaker Support.
Our dedicated support team will be more than willing to assist you in resolving the issue.