¶ When & Why
-
When the nuts on the CNC carving and cutting platform fall off.
-
The nut on the CNC carving and cutting platform may fall off after long-time use or under improper operation.
¶ Tools Required
- Tweezer (provided, in tool box)
- Brush
- AB glue
- Protective gloves
¶ Procedures
Before the operation, wear protective gloves to prevent contact with the toxic AB glue, and wear protective equipment to avoid inhaling volatile toxic gases.
- Clear the sawdust on the nut with the brush.
- Squeeze out the A glue and B glue in a 1:1 proportion.
Do NOT mistakenly screw the lid of the A glue on the B glue.
- Mix the A glue with the B glue with the mixing stick, and stir them evenly.
- Apply the mixed glue to the screw thread of the nut.
- Tweeze the nut back into the hole of the CNC carving and cutting platform, and press it for a while. Then, wait for at least 24 hours before reuse to ensure that the mixed glue is cured.
