¶ Before You Start
For ease of operation, you can first detach the laser engraving and cutting platform from the machine, fasten the material on the platform, and install the platform back onto the machine.
¶ Tools Required
For 10W laser machining:
- Laser material fixure × 4
- M6 × 16 screw × 8
For 20W/40W laser machining:
- Masking tape
¶ Procedures
Ensure that the fixtures will not overlap with the engraving and cutting area.
Ensure that the fastening tools will not collide with any parts of the machine.
¶ Method 1
Use the four provided fixtures to lock the position of the material as illustrated, and use two screws to secure each fixture.
¶ Method 2
Put a fixture on each corner of the material and tighten the screws to secure the material.
This method applies only to materials with less than 8 mm thickness.
Fix the material on the platform using masking tapes.
We do not recommend using the provided laser material fixture to fix the material for 20W/40W laser machining, as the fixtures may collide with the laser safety shield of the 20W/40W Laser Module during the task.