The XY work origin corresponds to the (0,0) coordinate origin of the canvas. The machine will only perform tasks in the expected area if the two origins are set consistently.
¶ Before You Start
Make sure you have completed the laser height adjustment and do not change the Z-axis height of the toolhead again.
If you set the work origin first, the horizontal position of the toolhead may change while adjusting the laser height.
¶ Procedures
To continue setting the work origin, select to read the corresponding content in accordance with your machine models.
-
Manually move the toolhead horizontally until the center of the red crosshairs falls on the desired position of the work origin.
-
In the Move panel, click Set Origin.
- Select the design object on the canvas, then click Frame to check the machining area. The machine will start running the boundary.
- In the Move panel, click X-/X+/Y-/Y+ to move the toolhead horizontally until the center of the red crosshairs falls on the desired position of the work origin.
- In the Move panel, click Set Origin.
- Select the design object on the canvas, then click Frame to check the machining area. The machine will start running the boundary.