Tips and notes for assembly

	At least two people are required to assemble and lift the machine and the Enclosure.
	Collect and sort the cables in time lest anyone should trip over them.
	Do NOT plug or unplug any cables when the machine is powered on.
	Take care to avoid injury from sharp edges of the steel strip. Do NOT press the steel strip. If the steel strip comes out, flatten it by hand from either end of the linear module to the other end.
	To install multiple screws in one step: 1. Pre-tighten the screws at the outermost corner. 2. Pre-tighten the remaining screws. 3. Tighten all the screws in the pre-tightening order. * Pre-tighten: To screw the screw into the hole, yet not fully tighten it.
	To install screws with the provided hex key: 1. Screw the screw into the hole with the long handle. 2. Tighten the screw with the short handle.