¶ Tools Required
- Palette knife × 1
¶ Procedures
- Wait several minutes until the nozzle and Heated Bed cool down to the ambient temperature as indicated by the Touchscreen. Remove the Print Sheet from the Heated Bed, and slightly bend the Print Sheet to detach the print edge from the Print Sheet.
Do not overbend the Print Sheet; otherwise, it may compromise the first layer adhesion.
- Place the Print Sheet on a stable and flat workbench. Gently scrape the print using its sharp edge.
To remove the print with ease, you can tape the Print Sheet before printing.
¶ Tools Required
-
Wiping cloth × 1
-
Tape × 1
-
Ethyl alcohol × 1
-
Knife × 1
¶ Procedures
- Clean the Print Sheet surface with alcohol.
- Tape the Print Sheet using adhesive tapes (≥ 1 mm) that are resistant to high temperature. Apply pressure to the tapes to smooth out air bubbles underneath using the flat blade.
- Trim the tape to fit the Print Sheet edge.
- Tape the entire Print Sheet. Ensure that the two sides of all tapes fit tightly, without any gaps.
- Since the printing will be performed on the tape, you should recalibrate the Heated Bed before printing.
- After the printing job completes, wait for the Heated Bed to cool down. Gently scrape your print from the tape using the palette knife. Adhesive tapes on the Print Sheet can be used for next printing job.
