¶ Tools Required
-
H2.5 screwdriver
-
M4 × 14 screws (The illustration is highlighted in yellow.)
¶ Procedures
This guide takes 3D printing of 350 models as a demonstration, all steps demonstrated apply to 250 models.
To continue installing the toolhead, select to read the corresponding content in accordance with whether the quick swap kit will be installed or not.
- Attach the toolhead bracket to the bracing plate.
- Slide the toolhead into the toolhead bracket, and then tighten the handle of the bracket.
- Connect the toolhead with the controller, and then lock the toolhead cable into the cable holder.
If you are using the 40W laser module or the 200W CNC module, use it with the power-boosted toolhead cable. The following illustration takes 40W laser module as a demonstration.
- Attach the toolhead to the bracing plate.
If you are installing the 20W / 40W Laser Module, use the provided M4 × 22 screws.
- Connect the toolhead with the controller, and then lock the toolhead cable into the cable holder.
If you are using the 40W laser module or the 200W CNC module, use it with the power-boosted toolhead cable. The following illustration takes 40W laser module as a demonstration.