¶ Tools Required
-
H2.5 screwdriver
-
M4 × 14 screws (The illustration is highlighted in yellow.)
¶ Procedures
This guide takes 350 models as a demonstration, all steps demonstrated apply to 250 models.
To continue installing the toolhead, select to read the corresponding content in accordance with whether the quick swap kit will be installed or not.
- Attach the toolhead bracket to the bracing plate.
- Attach the toolhead plate to the 200W CNC module.
- Slide the toolhead into the toolhead bracket, and then tighten the handle of the bracket.
- Connect the toolhead with the controller, and then lock the power-boosted toolhead cable into the cable holder.
- Attach the toolhead to the bracing plate.
- Connect the toolhead with the controller, and then lock the power-boosted toolhead cable into the cable holder.