¶ Before You Start
Make sure the machine is powered off.
Do NOT plug or unplug any cables when the machine is powered on.
¶ Tools & Accessories Required
- Air assist pump × 1
- M5 air tube connector × 1
- M8 air tube connector × 1
- Air tube × 1
- Cable tie × 2
¶ Procedures
- Attach the M5 air tube connector to the toolhead.
- Insert the air tube into the tube connector.
- Use the two cable ties to collect and fix the toolhead cable and the air tube.
- IF you have installed the Enclosure, thread the air tube through the snap bushing to the outside of the Enclosure.
- Attach the M8 air tube connector to the air assist pump.
- Insert the other end of the air tube into the M8 air tube connector.
- Connect the air assist pump conversion cable with the power cable of the air assist pump.
- Insert the air assist pump conversion cable into the Heated Bed port of the controller.
IF you have installed the Enclosure, please place the air assist pump outside the Enclosure. Therefore, you will need to thread the air assist pump conversion cable through the snap bushing into the Enclosure.