Before any assembly and installation, make sure the machine has been powered off.
¶ 1. Installing the toolhead
- Refer to Machine Assembly to install the platform bracket and the toolhead bracket.
- Loosen the handle of the toolhead bracket, and then slide the toolhead into the bracket.
- Adjust the height of the toolhead vertically until the top of the slider is level with the top of the bracket. Then, tighten the handle of the toolhead bracket.
- Attach the laser module to the slider on the X axis.
¶ 2. Connecting the toolhead
- Connect the laser module with the controller.
Specifically designed to power up the 40W laser module, the power-boosted toolhead cable is also compatible with other toolheads, which means that you do not need to replace the power-boosted toolhead cable when replacing toolheads.
- Lock the power-boosted toolhead cable into the cable holder.
- Connect the laser module with the controller.
- Lock the toolhead cable into the cable holder.
¶ 3. Installing the platform
- Refer to 2.2.2 Laser Engraving and Cutting to install the laser engraving and cutting platform.
- Attach the laser engraving and cutting platform to the support platform.