¶ Tools Required
-
H2.5 screwdriver
-
M4 × 8 screw
¶ Procedures
This guide takes 3D printing of 350 models as a demonstration, all steps demonstrated apply to 250 models.
- For subsequent assembly, move the Z-axis sliders to the farthest end.
- Detach the X axis.
- Attach the bracing plates to the Z axes.
Use the original M4 × 8 screws that came with the machine.
The rollers are equipped with a spring Self-adaptation adjustment structure, which reinforces the linear module's slider through the elastic force of the springs. The screws on the bracing plate are used for limiting the position of the spring Self-adaptation adjustment structure. To enable the elastic force of the springs, a certain amount of space for further tightening has been designedly reserved and the tightness of the screws has been pre-adjusted. It is not recommended to re-adjust the screws.
