¶ Tools Required
-
H2.5 screwdriver
-
M4 × 8 screw
-
M4 × 14 screw (The illustration is highlighted in yellow.)
¶ Procedures
This guide takes 3D printing of 350 models as a demonstration, all steps demonstrated apply to 250 models.
- Attach the X axis to the sliders on the Z axes.
- To align the X axis, put your hands at each end of the linear module, and then move the X axis to the top.
Make sure both ends of the Linear Module are in horizontal alignment with each other throughout the process.
- Attach the bracing plate to the X axis.
Use the original M4 × 8 screws that came with the machine.