¶ Tools Required
-
CNC bit
-
ER11 collet
-
ER11 nut
-
14mm Open-end wrench
-
17mm Open-end wrench
¶ Procedures
- Tilt the ER11 collet into the ER11 nut until the collet snaps into place. Insert the CNC bit into the ER11 collet until the shank bottoms against the collet.
Caution the sharp bits and keep them beyond the reach of children.
- Twist the ER11 nut onto the CNC Carving Module, and secure the nut using the open-end wrenches.
