If you are using the Dual Extrusion 3D Printing Module, after assembling the enclosure, follow the steps below to install the Filament Holder and the Filament Tube Holder.
¶ Procedures
- Detach the original Filament Holder from the Enclosure, and then install the new Filament Holder as illustrated.
- Insert the Sliding Nut into the 48CA Beam on the left of the Enclosure. Adjust the installation position of the Sliding Nut, in alignment with where the Snap Bushing is.
- Attach the new Filament Holder to the Sliding Nut.
- Press both sides of the Snap Bushing inside the Enclosure, and then gently push it out of the Side Panel.
- Mount the Filament Tube Holder and the Filament Tube onto the Side Panel.
- Remove the tube fixture from the filament entry, insert the Filament Tube into the module, and finally attach the tube fixture back.
