¶ Parts List
In the box, one toolhead plate and one toolhead bracket have been pre-assembled, and so have one platform plate and one platform bracket.
¶ Used Symbols
¶ Get the Screwdriver Ready
Get the screwdriver ready. The screwdriver head H2.5 is used for assembling the machine. Before use, ensure that the screw bit holder is put back into the handle.
¶ Procedures
- Attach the feet to the Base Plate.
- All Linear Modules must be assembled in their intended position. Now, identify two Linear Modules with the laser pattern "Lead 20 mm"; they will be the Y Axes.
- Make sure the sliders are aligning with each other. If not, you can move them to the same position as illustrated.
- It is recommended to use the Quick Swap Kit function. If you are using the Quick Swap Kit function, attach the Y Axes to the Platform Bracket. Do not tighten the screws until Step 6.
When using the Quick Swap Kit function, you need to install the complete kit, including the platform bracket and the toolhead bracket (illustrated in Step 25). Partial installation of the kit will result in abnormal operation.
The Platform is used for illustrating in subsequent illustrations, all steps demonstrated on the Platform apply to the Platform Bracket.
- If you are not using the Quick Swap Kit function, attach the Y Axes to the Platform. Do not tighten the screws until Step 6.
The Platform is used for illustrating in subsequent illustrations, all steps demonstrated on the Platform apply to the Platform Bracket.
- Attach the Y Axes to the Base Plate.
- Tighten the screws on the Y-axis sliders.
- Attach the Z-axis Holders to the Base Plate.
- Attach the Touchscreen Holder to the Base Plate.
- Identify the two Linear Modules with the laser pattern "Lead 08 mm". They will be the Z Axes.
- Thread the connecting cables through the holes of the holders, and then attach the Z Axes to the Z-axis Holders. Do not tighten the screws until Step 14.
- Install the screws to the bottom of the Z Axes. Do not tighten the screws until Step 15.
- From the middle, move the Platform to the position as illustrated. Then move the Z-axis sliders to the farthest end.
- The last Linear Module with the laser pattern "Lead 20 mm" will be the X Axis. Attach the X Axis to the Sliders on the Z Axes.
- Tighten the screws that are used to attach the Z Axes to the Z-axis Holders.
- Tighten the screws to the bottom of the Z Axes.
- Put your hands at each end of the Linear Module, and then move the X Axis to the top.
- Locate the Y Conversion Cable, and the attached cable on both of the two Y Axes as illustrated. Connect them to the Converter.
- Attach the Y-axis Converter to the Base Plate.
- Locate the Z Conversion Cable, and the attached cable on both of the two Z Axes as illustrated. Connect them to the Converter.
- Attach the Z-axis Converter to the Base Plate.
- Attach the Controller to the Z Axis.
- Open the dust plugs, and then connect the X, Y and Z Axes with the Controller.
- Place the Touchscreen, and then connect the Touchscreen with the Controller.
- Connect the cables for the Power Module.
- If you are using the Quick Swap Kit function, attach the Toolhead Bracket to the X axis.
Use the original M4 × 8 screws that comes with the machine.
When using the Quick Swap Kit function, you need to install the complete kit, including the platform bracket (illustrated in Step 4) and the toolhead bracket. Partial installation of the kit will result in abnormal operation.